Nortel Communication Server 1000S Installation And Configuration Manual page 82

Page 82 of 120 Configuring ISDN BRI hardware
553-3001-218 Standard 2.00
Non-BRI terminals
The M5000 is Nortel Networks's Universal Terminal Adapter (UTA). It
adapts a non-BRI data terminal or an analog (500/2500-type) telephone to the
ISDN BRI protocol. Attach a terminal to the M5000 terminal adapter to
initialize it. Refer to the M5000 terminal adapter user guide for detailed
configuration procedures.
Procedure 23
Initializing a Nortel Networks M5317TDX terminal
The following is an example of the steps to initialize an M5317TDX terminal.
Table 19 on page 83
terminal initialization. Additional information is contained in the M5317TDX
user guide.
1 Set the switch on the bottom of the terminal for either line power or local
power.
2 Plug in the M5317TDX terminal.
3 Press and hold down the RLS and HOLD keys as the terminal powers up.
4 Press MAINROM.
5 Press INSTALL.
6 Press ENGLISH or FRANCAIS for your choice of language.
7 Press the soft key of the TEI you want to set PHONE, DATA or X25.
Note: Dynamic TEI is only supported with firmware version 2.0 or higher.
8 Enter * for dynamic TEI.
9 Enter the TEI on the terminal keypad for static TEI.
10 Press OK when you have finished setting the TEIs.
11 Enter the phone (voice) SPID. Press OK when finished.
12 Enter the data SPID. Press OK when finished.
13 Enter the data DN. Press OK when finished.
14 Press HEADSET until REAR displays.
15 Press SIGTYPE until MER1 displays.
16 Press A/MU until MU-LAW displays.
17 Press MORE.
September 2004
lists and describes error codes that can appear during