Nortel Communication Server 1000S Installation And Configuration Manual page 26

Page 26 of 120 Installing ISDN BRI hardware
553-3001-218 Standard 2.00
3 Slide the BRSC, SILC, or UILC into the module until it engages the
backplane connector.
4 Push the card firmly into the connector using the locking devices as levers
by pushing them toward the card's front panel.
5 Push the tabs firmly against the front panel of the card so they latch to the
front lip in the module and to the post on the card.
6 Observe the red LED located on the faceplate.
• If the red LED turns on and stays lit continuously, the card is
defective. Remove the card, choose a new card, and repeat the
installation procedure.
• If it flashes three times and then turns off, the card is operating
correctly. Go to step 7.
• If the red LED flashes three times and then stays lit continuously, the
card is operating correctly but is not configured. Go to step 7.
7 On the CE or IPE Module card location form, fill in the card type and the
module number next to the slot number of the installed card.
8 Repeat steps 1 through 7 for each card requiring installation.
Procedure 6
Remove the BRSC, SILC, and UILC
Perform the following steps to remove the BRSC, SILC, and the UILC.
1 Hold the card by its card-locking devices. Squeeze the tabs to unlatch the
card-locking devices and lift them away from the card.
2 Carefully disengage the BRSC, SILC, or UILC from the backplane
connector, and slowly slide the card from the module.
September 2004
End of Procedure
End of Procedure