Page 24 of 120
Installing ISDN BRI hardware
Figure 4
Module cover locking latches
Large System
553-3001-218
Standard 2.00
6
Repeat steps 1 through 5 for each cover requiring removal.
Turn to unlock
Turn to unlock
Lock screw
Sliding Latch Knob
Procedure 3
Installing the MISP
Once covers have been removed and card slot locations selected for ISDN
BRI cards, install the MISP cards.
1
Hold the MISP by its card-locking devices. Squeeze the tabs to unlatch
the card-locking devices and lift the tabs out and away from the card.
2
Insert the MISP into the selected card slot of the module so it engages the
card guides in the module.
3
Slide the MISP into the module until it engages the backplane connector.
4
Push the MISP firmly into the connector using the locking devices as
levers by pushing them toward the card's front panel.
September 2004
End of Procedure
553-5458
Slide to
Slide to
unlatch cover
unlatch cover
553-7695