Isdn Bri Conference (National Isdn-1 And Etsi) - Nortel Communication Server 1000S Installation And Configuration Manual

4 Set PRES = NO in the TSP data block for the calling party ISDN BRI
terminal. If the calling party ISDN BRI terminal has an option on the set
to allow or restrict the presentation of the calling party number, select the
option to allow presentation and place a call to another ISDN BRI
terminal.
5 Observe the called party ISDN BRI terminal display. You should see the
number being displayed.
6 Release the call connection.

ISDN BRI Conference (National ISDN-1 and ETSI)

ISDN BRI Conference allows an ISDN BRI terminal user to bridge multiple
parties into a conversation. The user can:
• invoke Conference on a call
• add a new party to an existing call
• Call Join two separate parties on the terminal
• disconnect from the Conference
Procedure 31
Perform an ISDN BRI Conference test
Note: The same procedures can be used to test ISDN BRI NI-1 or ETSI
Conference.
1 In the DSL configuration in LD 27, set PRID = 6 to select the National
ISDN-1 protocol, or set PRID = 2 for the ETSI protocol.
2 In the TSP configuration in LD 27, define conference under FEATID:
FEATID aaa mmm <nnn>, where
aaa = A03 (3-party conference) or A06 (6-party conference)
mmm = feature activation ID (0 - 127)
nnn = feature indication ID (0 - 127) (If nnn is not entered, it is assumed
to be the same as mmm)
3 Select National ISDN-1 or ETSI protocol on the ISDN BRI terminal if
signaling type/protocol is configurable.
Testing ISDN BRI functions
ISDN Basic Rate Interface
Page 105 of 120
Installation and Configuration