Isdn Bri Etsi Call Forwarding Unconditional - Nortel Communication Server 1000S Installation And Configuration Manual

Page 110 of 120

ISDN BRI ETSI Call Forwarding Unconditional

553-3001-218 Standard 2.00
Testing ISDN BRI functions
Procedure 34
Perform an ISDN BRI NI-1 Call Forward All Calls test
The following is to test the forwarding of a voice call from an ISDN BRI
M5317 set.
1 Set up ISDN BRI NI-1 Call Forward All Calls in LD 27 (refer to the
"Configuring ISDN BRI features" chapter in ISDN Basic Rate Interface:
Features (553-3001-380)).
a. Select the NI-1 protocol for the DSL.
b. Configure the Call Forward All Calls feature ID for a particular DN and
call type (enter voice call type).
2 On the ISDN BRI terminal, configure ISDN BRI National ISDN-1 Call
Forward All Calls.
3 Configure two DN appearances on the ISDN BRI terminal (use the first
DN to forward a call, and the second DN to place a call to test the call
forward). On some ISDN BRI terminals, the second DN appearance
allows the user to initiate the second call.
4 Activate ISDN BRI National ISDN-1 Call Forward All Calls on the
ISDN BRI terminal, for the first DN:
a. Press the Forward key.
b. Dial the number where calls are to be forwarded.
c. Press the Forward key.
5 From the second DN, place a call to the first DN to verify that the call has
been forwarded.
6 To cancel National ISDN-1 Call Forward All Calls, Press the Forward
or the Cancel key.
The ISDN BRI ETSI Call Forwarding Unconditional (CFU) supplementary
service allows an incoming call to an ISDN BRI terminal to be forwarded to
a predetermined destination, within or outside the system. The call is
forwarded whether the user is busy or idle.
September 2004