Media Widt H Adj Ust M Ent - Datamax M-Class Mark II Operator's Manual

Au t om a t e d Pr in t h e a d Cle a n in g
1. Rem ove m edia and ribbon.
2. Place a Dat am ax- O'Neil Cleaning Card, part num ber 70- 2013- 01 under t he print head. Lower
and lock t he print head. Ensure t hat t he Media Widt h Adj ust m ent is not engaged.
3. Press and hold t he TEST Key for approxim at ely four seconds.
Th e pr in t e r w ill be gin t h e cle a n in g r ou t in e .
4. I n cases of heavy build- up, or if high heat values are t ypically used for print ing, flip t he card
over and repeat St ep 3.
5. Reinst all your ribbon and m edia ( if necessary, readj ust t he Media Widt h Adj ust m ent , see
Sect ion 5.3) . Lower and lock t he print head. Close t he cover.
5 . 3 M e d i a W i
5 . 3 M e d i a W i
5 . 3 M e d i a W i
When print ing on less t han full widt h m edia, adj ust for even pressure dist ribut ion, as follows:
1. Wit h m edia loaded in t he print er, print a label and exam ine it .
N on - displa y pr in t e r s:
Sim ult aneously press t he
D ispla y- e quippe d pr in t e r s:
See Sect ion 4.4
2. While observing t he print ed labels, loosen t he Thum bscrew 1/ 4 t urn. This keeps enough
t ension on t he screw prev ent ing t he t hum bscrew from slipping from t he desired posit ion while
st ill allowing for adj ust m ent . Slide t he t hum bscrew t o t he left m ost posit ion, ( see Exam ple 1,
below) .
3. Next , m ove t he Thum bscr ew t o t he right for each print ed t est label unt il t he labels cont ain a
com plet e, even im age ( see Exam ple 2) . Tight en t he Thum bscrew.
Ch a pt e r 5 – M a in t e n a n ce a n d Adj u st m e n t s
d t h A d j u s t m e n
d t h A d j u s t m e
d t h A d j u s t m e
PAUSE +
( Display- equipped print ers, only)
t
n t
n t
but t ons
FEED

Thum bscrew
4 9