Loading Media - Datamax M-class Mark II Operator's Manual

2 . 2 L o a d i n g M
2 . 2 L o a d i n g M
2 . 2 L o a d i n g M
Load media into the printer as follows:
1. Open the media cover and lower the Media Hub Guide and Media Guide.
2. Press in on the Printhead Latch and raise the Printhead Assembly.
3. Slide the Roll Media onto the Media Hub and raise the Media Hub Guide. The Media Hub Guide
should be pushed inward so that it is just touching the Roll Media.
4. Route the Media through the printer as shown. Raise the Media Guide. The Media Guide
should be pushed inward so that it is just touching the edge of the Media.
Chapter 2 - Printer Setup
e d i a
e d i a
e d i a
Printhead Latch
Media Guide
Media Hub Guide
Roll Media
Media Hub Guide
Media Sensor
Media Guide
5