Loading Printable Media - Datamax LP3 User Manual

LP 3 LABEL PRINTER USER'S GUIDE

Loading Printable Media

Media Guidelines
Media width
Roll capacity diameter 3.5"
Media types
Use the following procedure to load printable media:
1. Move the printer so that the front of the printer is facing
toward you.
2. While steadying the printer, push the two arrow buttons
toward each other while opening the printhead cover
(Figure 13).
3. Move the printer so that the left side of the printer is facing
toward you.
4. Remove the media ring from the spindle by pressing the
media ring's latches while pulling the media ring toward
you (Figure 14).
Figure 13
5. Load the media onto the spindle. When loaded correctly,
the media should form a figure "6" as shown in Figure 15.
1" to 3.125"
Linered label media, thermal paper
* Depending on the type of media used, you
may need to configure your printer. For more
information, see
page 14
.
Figure 14
7
Configuring the Printer on