Datamax M-Class Mark II Operator's Manual page 47

Com m u n ica t ion s
The Com m unicat ions m enu cont ains int erface and host cont rol funct ions:

Serial Port A

Parallel Port A

NI C Adapt er ( Et hernet )

Host Set t ings
The m enu select ions are defined as follows:
D I SPLAYED I TEM
SERI AL PORT A
BAUD RATE
( 1200 –
115000 BPS)
9600 BPS
PROTOCOL
BOTH
SOFTWARE
HARDWARE
NONE
PARI TY
NONE
ODD
EVEN
DATA BI TS
( 7 - 8)
8
STOP BI TS
( 1 - 2)
1
PARALLEL PORT A
PORT
DI RECTI ON
UNI -
DI RECTI ONAL
BI -
DI RECTI ONAL
NI C ADAPTER
QUI CK SETUP
WI RED DHCP
WLAN
UNSECURED
WLAN ADHOC
SET FACTORY
DEFAULTS
Ch a pt e r 4 – M e n u Syst e m
Cont rols t he RS- 232 com m unicat ions set t ings for Serial Port A, where:
Set s t he serial com m unicat ion rat e, where:
I s t he range, in Bit s Per Second; and,
is t he Default Set t ing.
Set s t he dat a flow cont rol ( handshaking) m et hod, where:
XON/ XOFF and CTS/ DTR are used. ( Default Set t ing)
XON/ XOFF is used.
CTS/ DTR is used.
Flow cont rol is not used.
Set s word parit y, where:
Parit y is not used. ( Default Set t ing)
Odd parit y is used.
Even parit y is used.
Set s word lengt h, where:
A seven or eight bit word is select able; and,
is t he Default Set t ing.
Set s t he num ber of st op bit s, where:
One st op or t wo st op bit s are select able; and,
is t he Default Set t ing.
Cont rols t he com m unicat ion set t ing for t he parallel port , where:
Det erm ines if dat a is ret urned from t he print er, where:
No dat a is ret urned; com m unicat ion is one- way.
Dat a is ret urned in com pliance wit h I EEE 1284 back- channel operat ion. ( Default
Set t ing)

An I EEE 1284 bidirect ional cable is required.
Cont rols t he com m unicat ions set t ings for t he net work int erface, where:
 I f a wireless card is inst alled, t his port is aut om at ically disabled;
t o enable t he wired LAN connect ion, disable t he Wireless Et hernet
MODE set t ing ( see below) .
Cont rols t he com m unicat ions set t ings for t he net work int erface, where:
Configures t he card for wired connect ion.
Configures t he card for wireless connect ion, wit h SSI D of " any"
Configures t he card for wireless connect ion, AdHoc m ode.
Reset s NI C Adapt er param et ers t o t he fact ory default s values.
I TEM D ESCRI PTI ON
4 1