Datamax M-Class Mark II Operator's Manual page 91

Pr oble m
Label Alignm ent is
incorrect . Pressing
FEED successively
result s in a label
lengt h longer t han
act ual, one- inch.
Tear Mode is select ed
but t he label st op
posit ion ( present
posit ion) is not far
enough forward.
Tear Mode is select ed
but t he label st op
posit ion ( present
posit ion) is t oo far
forward.
The ERROR light
illum inat es during
label alignm ent .
Appe n dix C – Pa pe r M e n u Se t u p
Possible Ca u se
Label Alignm ent
Lengt h is not correct .
The default Label
Alignm ent Lengt h is
1.00" , and will result in
t his behavior when any
larger label lengt h is
used wit hout set t ing
t he appropriat e lengt h
Anot her present
posit ion has been
det erm ined. Enabling
t he Present Sensor
causes t he label st op
posit ion ( present
posit ion) t o be
approxim at ely 0.1"
behind t he peel bar.
~ OR~
The Present Adj ust
value is not correct .
Anot her present
posit ion has been
det erm ined.
~ OR~
The Present Adj ust
value is not correct .
The label supply is
em pt y
Solu t ion

Set Label Alignm ent t o AUTO. Press and hold
unt il paper m oves for aut om at ic Label
FEED
Alignm ent lengt h m easur em ent .
~ OR~

Measure t he label lengt h and use t he Set up
Menu t o set t he new lengt h. Print a Dat abase
Configurat ion label t o ensure t he new lengt h has
been set .

Disable t he Present Sensor.
~ OR~

Ensure t he host com put er is not providing a
Present Dist ance short er t han is required for t he
Tear Bar.

Use t he Set up Menu t o m odify t he Present
Adj ust value.

Ensure t he host com put er is not providing a
Present Dist ance longer t han is required for t he
Tear Bar.

Use t he Set up Menu t o m odify t he Present
Adj ust value.

Load m edia.
8 5