Transmitting A File Stored On Floppy Disk (Multiple Address) - Furuno FELCOM 15 Operator's Manual

22. Press the [Enter] key to open the Start window.
23.Press the [Enter] key to send the message to the message buffer. (To escape,
choose "No" and press the [Enter] key.) The message "Message is entered in
sending Buffer." appears and the message prepared is printed.
Note: The message buffer can only hold one message. However, a second
24. Press any key to return to the standby display.
The message(s) will be transmitted according to the Send Delay setting.
"Current State: SENDING" appears at the bottom of the screen while the
message is being transmitted. .
If the message was transmitted successfully, "Successful Sending message"
appears and its particulars are sent to the Display Log.
"The terminal unit displays transmit message status as follows:
"Message Send failed." This appears if the message could not
be transmitted because of technical reasons such as satellite
malfunction, signal degradation, or no reply from LES. Try to
transmit the message again.
Message Send rejected." This appears when the LES rejects
the message because of non-technical reasons such as unpaid
subscriber's fee.
" Message Send pending." This appears when the circuits at the
LES are busy. Your message will be transmitted when a circuit
becomes clear.
4.1.3

Transmitting a file stored on floppy disk (multiple address)

1. Close any open files.
2. Insert floppy disk containing file to be sent.
3. Press the function key [F3] to display the Transmit menu.
message may be sent to the buffer by assigning a Send Delay to it.
When the message buffer is full, "Cannot enter this message to
sending Buffer." appears to alert you.
TRANSMIT MESSAGE STATUS
4. INMARSAT C COMMUNICATIONS
4-9