Furuno FELCOM 15 Operator's Manual page 32

7. Press the [Enter] key to open the options window.
System setup menu, preferred NCS options window
8. Choose appropriate NCS (Auto, AOR-West, AOR-East, POR or IOR) by
using the arrow keys. The FELCOM will search for that NCS signal each time
it is turned on. The "Auto" setting searches all NCS signals to find the most
suitable NCS; thus scanning can take quite some time. (For reference, the
coverage range of each satellite is shown in the illustration on page 3.)
Note: If you want to change the NCS channel temporarily, refer to paragraph
7.4.
9. Press the [Enter] key to close the options window.
10. Press the [↓] key to choose MES Operation Mode.
11. Press the [Enter] key to open the options window.
System setup menu, MES operation mode options window
12. Choose operating mode, Inmarsat C or EGC. The Inmarsat C setting
provides telex communications and operates as an EGC receiver when the
equipment is not transmitting or receiving. The EGC setting enables
EGC-only operation. In this case, "EGC RECEIVER" appears in reverse
video at the bottom of the screen.
13. Press the [Enter] key to close the options window.
14. Press the [↓] key to choose Nav Port.
15. Press the [Enter] key to open the options window.
System setup menu, nav port options window
Setup
System Setup
System Date & Time 01:53 02-02-25 (YY-MM-DD)
IMN IOR
Preferred NCS INMARSAT-C Auto
AOR (WEST)
MES Operation Mode OFF
AOR (EAST)
Nav Port DTE1
POR
Active Port DTE1
IOR
Message Output Port
9. Configuration
EGC Output Port
Setup
System Setup
System Date & Time 01:53 02-02-25 (YY-MM-DD)
IMN
Preferred NCS IOR
MES Operation Mode INMARSAT-C INMARSAT-C
Nav Port OFF EGC
Active Port
Message Output Port INT
9. Configuration
EGC Output Port INT
Setup
System Setup
System Date & Time 01:53 02-02-25 (YY-MM-DD)
IMN
Preferred NCS IOR
MES Operation Mode INMARSAT-C
Nav Port DTE1OFF
OFF
Active Port DTE1
EXT
Message Output Port DTE1
INT
9. Configuration
EGC Output Port
2. SYSTEM INITIALIZATION
2-3