2-14.
CN-3647 Board/SW-1608A Board
Preparation
1.
Remove the inside panel assembly. (Refer
2.
Remove the intercom panel. (Refer
Procedure
1.
Disconnect the harness from the connector (CN1) on the CN-3647 board.
2.
Remove the two screws to detach the CN-3647 board.
CN-3647 board
CN1
Harness
3.
Remove the ENCODER knob.
4.
Remove the four screws to detach the SW-1608A board.
5.
Disconnect the flexible flat cable from the connector (CN1) on the SW-1608A board.
Note
Be careful not to bend the flexible flat cable. This shortens the wire life.
6.
SW-1608A 基板から以下の部品を取り外す。
• INCOM waterproof sheet
• Earth plate
• Switch cap
• Waterproof rubber
B2 x 5
CN1
Flexible flat
cable
Waterproof rubber
7.
Install the removed parts by reversing the steps of removal.
HSC300RF/HSC100RF/HSC300R/HSC100R
to"2-1. Inside
Panel")
to"2-13. Intercom
Panel")
BVTP 3 x 10
SW-1608A board
Earth plate
SW cap
IINCOM waterproof sheet
BVTP 3 x 10
ENCODER knob
2-33