Table of Contents
Advertisement
2-3-6.
SW-1603 Board/VR-351 Board
Preparation
1.
Remove the elbow assembly. (Refer to
Procedure
1.
Remove the four screws to detach the VF case (front).
2.
Remove the four screws to detach the LCD block.
3.
Disconnect the harness from the connector (CN100) on the VR-351 board.
4.
Remove the screw to detach the VR-351 board.
5.
Disconnect the harness from the connector (CN100) on the SW-1603 board.
6.
Remove the three switch knobs (VF).
PMW-300
"2-3-4. Elbow
Assembly")
VF case (front)
B2 x 5
LCD block
P2 x 3
P2 x 3
B2 x 5
2-14
Advertisement
Table of Contents
