6.
Remove the four hexagon cap screws and four spring washers to detach the front panel.
ND filter knob
Front panel
HEXAGON 3 x 8
B2 x 5
Note
Apply threadlocker to the setscrews, then tighten them.
7.
Remove the three screws and remove the transportation case from the CCD unit for repair (option).
Transportation case
P3 x 6
8.
Install the removed parts by reversing the steps of removal.
Work after replacement
Perform the following after the CCD unit is replaced.
• Refer
to"3-3. Electrical Alignment"
• Refer
to"3-6. RPN Compensation"
• Refer
to"5-7. OHB File"
HSC300RF/HSC100RF/HSC300R/HSC100R
CC filter knob
SW3
Mount lever
Setscrews
CCD unit for repair
2-10