4.
Remove the four hexagon cap screws and the four spring washers to detach the front panel.
Filter select knob
Front panel
HEXAGON 3 x 8
Note
• Attach the filtr select knob using the following steps.
(1) Turn the knob shaft to a position where the filter with the lightest color (1: clear) appears when viewed
from the lens mount section.
(2) Match the filter select knob number 1 with the mark on the front panel, and secure the knob with a setscrew.
• Apply threadlocker to the setscrew, then tighten them.
5.
Remove the three screws and remove the transportation case from the CCD unit for repair (option).
Transportation case
P3 x 6
6.
Install the removed parts by reversing the steps of removal.
Work after replacement
Perform the following after the CCD unit is replaced.
• Refer
to"3-3. Electrical Alignment"
• Refer
to"3-6. RPN Compensation"
• Refer
to"5-7. OHB File"
HSC300RF/HSC100RF/HSC300R/HSC100R
Setscrew
SW3
Knob shaft
Filter with the
lightest color
(1: clear)
Mark
CCD unit for repair
2-12