Filter Servo Board/Filter Disk (Hsc300R/300Rf) - Sony Power HAD FX HSC300R Service Manual

2-4-5.

Filter Servo Board/Filter Disk (HSC300R/300RF)

Note
When replacing the filter servo board, replace the filter disk unit with the filter servo board contained.
Preparation
1. Open the outside panel assembly.
• HSC300R/100R: Refer
• HSC300RF/100RF: Refer
2. Remove the CCD unit. (Refer
Procedure
1. Open the filter clamp.
2. Disconnect the harness from the connector (J2) on the filter servo board.
3. Remove the two screws (PSW2 x 5) to detach the filter servo board.
4. Remove the two screws (K3 x 4) to detach the filter disk.
5. Remove the EMC spring (motor).
Filter disk
K3 x 4
6. Install the removed parts by reversing the steps of removal.
HSC300RF/HSC100RF/HSC300R/HSC100R
to"2-2-1. Outside Panel Assembly (TRIAX)"
to"2-3-1. Outside Panel Assembly (Fiber)"
to"2-4-1. CCD Unit (HSC300R/300RF)")
EMC spring (motor)
Harness
Harness clamp
J2
Filter servo board
PSW2 x 5
2-15