Table of Contents
Advertisement
2-6. Replacement of Board
2-6-1. Note on Replacement of Parts
Every electrical part mounted on the LF-31, PR-211 and
CN-1142 boards cannot be replaced. If there is any
defective part, replace the board itself.
The PR-211 board is provided with a termination board
CN-1142 on it. The CN-1142 board is necessary when the
PR-212 board of OHB-500WS/500WSP is not installed.
Unless the PR-212 board is installed, be sure to connect the
CN-1142 board to the PR-211 board.
2-6-2. Replacement of CN-988/989/990 Board
The CN-988/989/990 boards are small printed circuit
boards used for the camera's right side panel equipped
with the REMOTE connector and so on. If you order one
of these boards, a combined board of the above three will
be supplied from the Sony parts center. So, please cut off
a necessary board from it and use for service.
BVP-500
BVP-500P
2-6-3. Replacement of PR-211 Board
n
In replacing the PR-211 board, a screwdriver whose blade
is long (blade length: 200 mm or more) is required. (Sony
P/N:7-700-739-01 or equivalent)
1. Open the left side panel referring to Section 2-1.
2. Remove the four screws to remove the PR-211 board.
3. Disconnect the flexible card wire referring to Section
2-5.
PR-211
X
B3
4
4. Install a new board in the reverse procedures of
removal.
2-6. Replacement of Board
2-7
Advertisement
Table of Contents
