Power Switch Removal
Tools Required
•
TORX screwdriver, T10, T15 and T20.
Procedure
Refer to Figure 5-6 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 178.
Step 2. Remove the A1 switch control board as described in "A1 Switch Control Board Removal"
on page 181.
Step 3. Disconnect the power cable (item 1).
Step 4. Remove the two TORX T20 screws (item 2) from the chassis.
Step 5. Pull out the three terminals (item 3) from the AC receptacle terminal.
Step 6. Disjoint the joint (item 4) from the power switch and the rod.
Step 7. Remove the two TORX T10 screws (item 5) from the chassis and remove the power
switch.
Figure 5-6
Power Switch Assembly Removal
Chapter 5
Replacement Procedure
Replacement Procedure for E5092A-020
183