Replacement Procedure For E5092A-020; Outer Cover Removal - Agilent Technologies ENA Series Service Manual

Replacement Procedure

Replacement Procedure for E5092A-020

Replacement Procedure for E5092A-020

Outer Cover Removal

Tools Required
•
Procedure
Refer to Figure 5-1 for this procedure.
Step 1. Disconnect the power cable from the E5092A.
Step 2. Remove the two TORX T20 screws (item 1) fastening the side strap handles.
Step 3. Remove the four TORX T15 screws (item 2) fastening the four rear foot.
Step 4. Remove the five TORX T15 screws (item 3) fastening the cover from the rear side.
Step 5. Remove the four bottom feet (item 4).
Step 6. Remove the two TORX T10 screws (item 5) fastening the cover from the bottom.
Step 7. Slide the outer cover and remove it carefully.
Figure 5-1 Outer Cover Removal
178
TORX screwdriver, T10, T15, and T20
Chapter 5