Agilent Technologies ENA Series Service Manual page 204

Post-Repair Procedures
Post-Repair Procedures
Table 6-1 Post-Repair Procedures
Replaced
Assembly or Part
Switch 10 (20GHz SPDT Pin
Switch Module) (P9397-60001)
Switch 1 (20GHz SP4T Pin
Switch Module) (P9398-60001)
Switch 2 (20GHz SP4T Pin
Switch Module) (P9398-60001)
Switch 3 (20GHz SP4T Pin
Switch Module) (P9398-60001)
Switch 4 (20GHz SP4T Pin
Switch Module) (P9398-60001)
198
Required
Adjustments
Correction Constants
(CC)
Not adjustment needed
No adjustment needed
No adjustment needed
No adjustment needed
No adjustment needed
Verification
Perform the following performance tests.
- Write SN
- Load Match, Insertion Loss and Isolation Test
for Switch 10 (SPDT, 10COM, 10A and 10B)
- LED Check
- DCBUS Check
Perform the following performance tests.
- Write SN
- Load Match, Insertion Loss and Isolation Test
for Switch 1 (SP4T, Port1, 1A, 1B, 1C and 1D)
- LED Check
- DCBUS Check
Perform the following performance tests.
- Write SN
- Load Match, Insertion Loss and Isolation Test
for Switch 2 (SP4T, Port2, 2A, 2B, 2C and 2D)
- LED Check
- DCBUS Check
Perform the following performance tests.
- Write SN
- Load Match, Insertion Loss and Isolation Test
for Switch 3 (SP4T, Port3, 3A, 3B, 3C and 3D)
- LED Check
- DCBUS Check
Perform the following performance tests.
- Write SN
- Load Match, Insertion Loss and Isolation Test
for Switch 4 (SP4T, Port4, 4A, 4B, 4C and 4D)
- LED Check
- DCBUS Check
Chapter 6