E5092A Setting Troubleshooting; Check The E5092A Setting - Agilent Technologies ENA Series Service Manual

E5092A Setting Troubleshooting

Check the E5092A Setting

Step 1. Connect the USB cable furnished with E5092A between the rear panel of the E5071C and
that of the E5092A.
Step 2. Turn on the E5071C and the E5092A.
Step 3. Immediately, after power-on, LEDs of port A for all port connection of the E5092A go on.
NOTE If the E5071C is not powered on or if the E5071C and the E5092A are not connected with
the USB cable, LEDs of port A for all port connection of the E5092A stay off
Step 4. Press
Step 5. Press
NOTE The enable (
for all channels.
Step 6. Press
Figure 3-4 E5092A property
NOTE
The enable (
channels.
Step 7. Use the corresponding softkey to assign between the test ports of the E5092A and the
Chapter 3
-
Multiport Test Set Setup
to enable ( ) the control of the E5092A.
Control ON
)/disable ( ) setting of the control function of the E5092A is executed
ON OFF
Property to enable ( ON ) the control of the E5092A as shown in Figure 3-4.
ON )/disable ( OFF ) setting of theE5092A property display is executed for all
E5092A Setting Troubleshooting
- to display the Test Set 1 menu.
Test Set 1
Troubleshooting
141