A1 Switch Control Board Removal - Agilent Technologies ENA Series Service Manual

A1 Switch Control Board Removal

Tools Required
• TORX screwdriver, T10, T15 and T20.
Procedure
Refer to Figure 5-4 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 178.
Step 2. Disconnect all the cables connected on the A1 Switch control board.
Step 3. Remove the two TORX T10 screws (item 1) from the rear panel.
Step 4. Remove the six TORX T10 screws (item 2) fastening the A1 board.
Step 5. Remove the A1 board from the chassis.
Figure 5-4 A1 Switch Control Board Removal
Chapter 5
Replacement Procedure
Replacement Procedure for E5092A-020
181