Removing The Power Supply Regulator Assembly; Removing The Power Supply Assembly - Agilent Technologies 8935 Series Manual

Removing the Power Supply Regulator Assembly

To remove the A3A1 regulator assembly, disconnect the cables and the
four torx screws shown in
Figure 5-18 A3A1 Regulator Assembly
W223
W222
A3A1 Assembly

Removing the Power Supply Assembly

1. Remove the regulator assembly.
2. Remove the power supply cover from the A3 assembly, see
3. Disconnect cables W222, W223, and GFI-assembly cable at J7.
4. Remove the four screws securing the power supply to the rear sub
Chapter 5
W221
W220
Battery Cable
(part of A3A4)
5-19 on page 128.
panel.
Figure 5-18.
Regulator Assembly
A3A1
Power Switch Cable
(part of A3S1)
Fan Cable
(part of A3A1)
reg_rmv2.eps
Disassembly
A3 Disassembly
Figure
127