Generator; Disassembling And Assembling; External Component - Kubota WSM J Series Workshop Manual

J SERIES, WSM

2. GENERATOR

[1] DISASSEMBLING AND ASSEMBLING

(1)

External Component

Cover, Panel, Control Panel, Bonnet and Fuel Tank
1. Place the machine on firm and level surface.
2. Remove the both side cover (2).
3. Remove the negative wire from the battery and disconnect the
lead wire from the stop solenoid, the glow plug, the water
temperatur sensor, oil switch, the alternator (AC dynamo), the
fuse box, and the earth.
4. Drain the coolant and engine oil, and remove each fuel hose.
5. Remove the muffler pipe (7), fuel tank cap (6), rubber seal (5),
and the bonnet (4).
6. Remove the fuel tank (1).
7. Remove the generator's rear cover (3) and disconnect the lead
wire from the stator coil.
8. Remove the control panel (8).
9. Remove the radiator hose both side and the panel with the
radiator (9).
(1) Fuel Tank
(2) Side Cover
(3) Generator's Rear Cover
(4) Bonnet
(5) Rubber Seal
S-49
GENERATOR
(6) Fuel Tank Cap
(7) Muffler Pipe
(8) Control Panel
(9) Panel with the Radiator
W12445040
KiSC issued 10, 2016 A