Kubota WSM J Series Workshop Manual page 112

J SERIES, WSM
(C) Timing Gear, Camshaft and Fuel Camshaft [D1005, V1305]
Fan Drive Pulley
1. Set the stopper to the flywheel.
2. Remove the fan drive pulley retaining screw (1).
3. Draw out the fan drive pulley (2) with a puller.
(When reassembling)
• Install the fan drive pulley to the crankshaft, aligning the aligning
marks (3) on them
Fan drive pulley retaining
Tightening torque
screw
(1) Crankshaft Screw
(2) Fan Drive Pulley
Water Pump
1. Remove the water pump flange.
(When reassembling)
• Before installing the water pump flange gasket, apply liquid
gasket (Three Bond 1215 or equivalent) to the both side.
S-66
ENGINE
235 to 245 N·m
24.0 to 25.0 kgf·m
174 to 181 ft-lbs
(3) Aligning Marks
W10181950
W10243100
KiSC issued 10, 2016 A