Kubota WSM J Series Workshop Manual page 159

J SERIES, WSM
(C) Dynamo [Z482, D722]
(D) Alternator [D1005, V1305]
Stator
1. Remove the nut (3) and separate the stator comp (4).
2. Unscrew the screws (1) and remove the stator (2).
(1) Screw
(2) Stator
Rotor
1. Tap out the shaft (1) from the rotor (3).
(When reassembling)
• Take care the direction of the collar (4), the flat side should face
to the pulley (2) side.
(1) Shaft
(2) Pulley
(3) Rotor
Pulley
1. Secure the hexagonal end of the pulley shaft with a double-
ended ratchet wrench in as shown the figure, loosen the pulley
nut with a socket wrench and remove it.
(When reassembling)
Tightening torque Pulley nut
Rear End Cover
1. Unscrew the three rear end cover screws and the B terminal nut,
and remove the rear end cover.
Brush Holder
1. Unscrew the two screws holding the brush holder, and remove
the brush holder (1).
(1) Brush Holder
S-113
ENGINE
(3) Nut
(4) Stator Comp
W1152409
(4) Collar
(5) Bearings
(6) Collar
W1152529
58.3 to 78.9 N·m
5.95 to 8.05 kgf·m
43.0 to 58.2 ft-lbs
W1152727
W1152806
W1153002
KiSC issued 10, 2016 A