Kubota WSM J Series Workshop Manual page 142

J SERIES, WSM
Replacing Crankshaft Bearing 1
(When removing)
1. Press out the used crankshaft bearing 1 using a crankshaft
bearing 1 replacing tool.
(When installing)
1. Clean a new crankshaft bearing 1 and crankshaft journal bore,
and apply engine oil to them.
2. Using a crankshaft bearing 1 replacing tool, press in a new
bearing 1 (2) so that its seam (1) directs toward the exhaust
manifold side. (See figure)
Dimension (A) Factory spec.
(1) Seam
(2) Crankshaft Bearing 1
S-96
ENGINE
0.0 to 0.3 mm
0.00 to 0.012 in.
(3) Cylinder Block
W10342000
KiSC issued 10, 2016 A