Kubota WSM J Series Workshop Manual page 158

J SERIES, WSM
(B) Starter [D1005, V1305]
Starter Motor
1. Disconnect the connecting lead.
2. Remove the mounting nuts.
3. Remove the magnet switch by sliding it up so that is
disconnected from the driver lead.
Brush Holder
1. Draw out the brush from the holder while holding the spring up.
2. Remove the brush holder.
(When reassembling)
• Do not damage the brush, commutator and bearing.
Armature
1. Draw out the armature (1).
(1) Armature
Housing, Idle Gear and Overrunning Clutch
1. Remove the housing (3).
2. Remove the idle gear (1) and the overrunning clutch (2).
NOTE

• Do not damage the clutch bearing and do not let the dust
adhere to it.
• Do not lose the steel ball in the overrunning clutch.
(1) Idle Gear
(2) Overrunning clutch
Plunger
1. Remove the end cover (1) of solenoid switch (4).
2. Remove the plunger (2) and spring (3).
(1) End Cover
(2) Plunger
S-112
ENGINE
W1151715
W1151798
W1151894
(3) Housing
W1151974
(3) Spring
(4) Solenoid Switch
W1152123
KiSC issued 10, 2016 A