Disassembling And Assembling - Kubota WSM J Series Workshop Manual

J SERIES, WSM

(2) Disassembling and Assembling

(A) Starter [Z482, D722]
1. Unscrew the mounting nut (6), and disconnect the connecting lead (11).
2. Unscrew the solenoid switch mounting nut (1), and remove the solenoid switch (5)
3. Remove the end frame cap (16).
4. Remove the brake shoe (15), brake spring (14) and gasket (13).
5. Unscrew the through bolts (21), and remove the rear end frame (12).
6. Remove the brush from the brush holder while holding the spring up.
7. Remove the brush holder (20).
8. Draw out the yoke (18) from the starter drive housing (2).
9. Draw out the armature (9) with the drive lever (3).
NOTE

• Do not damage to the brush and commutator.
(When reassembling)
• Apply grease to the parts indicated in the figure.
(a) Joint of solenoid switch
(b) Bushing
(c) Drive lever
(d) Collar
(e) Teen of pinion gear
(f) Armature shaft
S-111
ENGINE
(1) Solenoid Switch
Mounting Nut
(2) Starter Drive Housing
(3) Drive Lever
(4) Gasket
(5) Solenoid Switch
(6) Nut
(7) Snap Ring
(8) Overrunning Clutch
(9) Armature
(10) Brush Spring
(11) Connecting Lead
(12) Rear End Frame
(13) Gasket
(14) Brake Spring
(15) Brake Shoe
(16) End Frame Cap
(17) Screw
(18) Yoke
(19) Bush
(20) Bush Holder
(21) Through Bolt
W1151206
KiSC issued 10, 2016 A