Kubota WSM J Series Workshop Manual page 116

J SERIES, WSM
Fork Lever
1. Remove the start spring (7).
2. Remove the fork lever shaft cover (1).
3. Pull out the fork lever shaft (4), and remove the spacer (2),
bearing (3), fork lever 1 (6) and fork lever 2 (5).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) to the both
sides of the fork lever shaft cover, and fit the fork lever shaft cover
with the "UP" mark facing upwards.
• Securely fit the start spring.
IMPORTANT

• Install the fork lever 2 (5) to position it on the right side of the
maximum output limit bolt (8) as shown in the figure.
(1) Fork Lever Shaft Cover
(2) Spacer
(3) Bearing
(4) Fork Lever Shaft
Camshaft and idle Gear
1. Remove the external snap ring, and then remove the idle gear
(4).
2. Remove the camshaft stopper mounting screw, and pull out the
camshaft (6).
(When reassembling)
• Apply engine oil to the idle gear shaft mounting screws.
And tighten them.
• When installing the idle gear, be sure to align the alignment
marks (a), (b) and (c) on the gears.
• Securely fit the external snap ring and stopper.
(1) Injection Pump Gear
(2) Governor Gear
(3) Crank Gear
(4) Idle Gear
(5) Cam Gear
(6) Camshaft
Idle gear shaft mounting
Tightening torque
screw
S-70
ENGINE
(5) Fork Lever 2
(6) Fork Lever 1
(7) Start Spring
(8) Maximum Output Limit Bolt
W10259770
(a) Alignment Mark (Idle Gear and
Cam Gear)
(b) Alignment Mark (Idle Gear and
Crank Gear)
(c) Alignment Mark (Idle Gear and
Injection Pump Gear)
9.8 to 11.3 N·m
1.00 to 1.15 kgf·m
7.2 to 8.3 ft-lbs
W10263250
KiSC issued 10, 2016 A