Kubota WSM J Series Workshop Manual page 103

J SERIES, WSM
Stop Solenoid [D1005, V1305]
1. Disconnect a lead wire (1) from ST terminal on starter.
3L
2. Key switch turn to "ON" position, then the solenoid should
ST
3. Remove the solenoid and check the continuity of pull-coil and
MB
4. Replace the solenoid if it is defective.
(1) Lead Wire
operate strongly with an audible click, if not.
hold-coil as well as checking plunger moving.
S-57
GENERATOR
(a) Starter
W1117759
KiSC issued 10, 2016 A