Kubota WSM J Series Workshop Manual page 160

J SERIES, WSM
IC Regulator
1. Unscrew the three screws holding the IC regulator, and remove
the IC regulator (1).
(1) IC Regulator
Rectifier
1. Remove the four screws holding the rectifier and the stator lead
wires.
2. Remove the rectifier (1).
(1) Rectifier
Rear End Frame
1. Unscrew the two nuts and two screws holding the drive end
frame and the rear end frame.
2. Remove the rear end frame (1).
(1) Rear End Frame
Rotor
1. Press out the rotor (1) from drive end frame (3).
IMPORTANT

• Take special care not to drop the rotor and damage the slip
ring or fan, etc.
(1) Rotor
(2) Block
Retainer Plate
1. Unscrew the four screws holding the retainer plate, and remove
the retainer plate (1).
(1) Retainer Plate
S-114
ENGINE
W1154950
W1155083
W1155181
(3) Drive End Frame
W1155270
W1155392
KiSC issued 10, 2016 A