Kubota WSM J Series Workshop Manual page 115

J SERIES, WSM
Governor Shaft
1. Remove the external snap ring (1) from the governor shaft (2).
2. Pull out the governor shaft (2).
(When reassembling)
• Make sure assembling the external snap ring of the governor
shaft.
• Check the governor shaft for smooth rotation.
IMPORTANT

• When replacing the ball bearing of governor shaft, securely
fit the ball bearing (3) to the crankcase, apply an adhesive
(Three Bond 1324B or equivalent) to the set screw (4), and
fasten screw until
circumferential end of the ball bearing.
(1) External Snap Ring
(2) Governor Shaft
S-69
its tapered part contacts
(3) Ball Bearing
(4) Set Screw
KiSC issued 10, 2016 A
ENGINE
the
W10257780