Connecting The Antenna Cable (Su-Re And Au-Re) - Alvarion BreezeACCESS II System Manual

1-12
Connecting the Antenna Cable
(SU-RE and AU-RE)
Connect an RF cable between the ANT connector (located on the top
panel of the unit) and the antenna.
Connecting the Ground and IF Cables
The ground terminal (marked ) and the IF cable connector (marked IF)
are located on the bottom panel of the unit.
1. Connect one end of the ground cable to the ground terminal and tighten the
ground screw firmly. Connect the other end of the ground cable to a
protective ground connection.
2. Connect the coaxial cable to the IF connector. Verify that the length of the
IF cable is sufficient and that it can easily reach the indoor unit.
NOTE:
Make sure to switch off the power at the indoor unit prior to connecting/disconnecting
the IF cable to/from the outdoor unit.
Manual Revision: 3.0
BreezeACCESS Version 4.3 Installation