Software Version - Alvarion BreezeACCESS II System Manual

General
Firmware upgrades to the unit's FLASH memory are performed by a
simple loading procedure using a TFTP application. Before performing
an upgrade procedure, be sure you have the correct files and latest
instructions.
NOTE:
Shutting down power to the unit before completion of the loading procedure may cause
the unit to be inoperable.
Verify that you have IP connectivity to the unit to be loaded with a new
version. Verify that the IP address of the PC from which you intend to
perform the upgrade belongs to the same subnet as the unit to be
upgraded (unless the unit is behind a router). If the unit is behind a
router, verify that the unit is configured with the correct Default
Gateway Address.
To view the current IP parameters of the unit, use the monitor program
by connecting the PC to the unit either directly or via Telnet and use the
following procedure:
1.
From the Main Menu select 1 – Info Screens.
The Info Screens menu opens.
2.
From the Info Screen menu select 2 – Show Basic Configuration.
A display of the current configuration of the basic parameters
appears, including the IP Address, Subnet Mask and Default
Gateway Address parameters.
To configure any of the IP parameters, use the following procedure:
1.
From the Main Menu select 3 – Basic Configuration.
The Basic Configuration menu opens.
2.
To configure the IP Address, select: 1 – IP Address.
3.
To configure the Subnet Mask, select 2 – Subnet Mask.
4.
To configure the Default Gateway Address select 3 – Default
Gateway Address.
5.
Reset the unit in order for the new configuration to apply.
Appendix B:

Software Version

Loading Procedure