Alvarion BreezeACCESS II System Manual page 226

2-90
1200-baud tone modulation in accordance with Bellcore 202
standard.
The Caller ID parameter is supported only by units using a Voice card
HW revision D and higher.
The following options are available:
Disable
ETSI DT-AS: CID signaling in accordance with ETSI
ETS 300 659 -1, using Dual Tone Alerting Signal to indicated to
the called terminal that CID data transmission is to be expected.
ETSI RP-AS: CID signaling in accordance with ETSI
ETS 300 659 -1, using Ringing Pulse Alerting Signal to indicate
to the called terminal that CID data transmission is to be
expected.
ETSI – During Ringing: CID signaling in accordance with ETSI
ETS 300 659 -1, transmitting CID data during the first long
silence between two ring patterns.
Bellcore MDMF: CID signaling in accordance with Bellcore 202,
using Multiple Data Message Format (MDMF), which includes a
name field in addition to the date, time and number.
Bellcore SDMF: CID signaling in accordance with Bellcore 202,
using Single Data Message Format (SDMF), which includes the
date, time and number.
The default selection is Disable.
Stop Dialing Timeout: The inactivity time following the last dialed
digit that will be identified by the unit as an indication to end of
dialing.
Valid range: 3 to 60 seconds
Default value: 5 seconds
Stop Dialing Indicator: Uses the # sign to indicate end of dialing,
thus to speed the dialing process. The options are:
Disable: The # sign is interpreted as a part of the dialed
sequence. End of dialing is determined by the Stop Dialing
Timeout parameter.
Enable: The # sign is interpreted as indicating end of dialing
sequence.
The default is Disable.
Overlap Sending - To enable or disable the overlap sending feature.
A gatekeeper or a gateway supporting overlap sending does not
require dialing termination signaling for setting up a call. Otherwise
a dialing termination signal must be supplied by the unit.
When Overlap Sending is enabled, each dialed digit is transmitted
immediately. When disabled, dialed digits are accumulated and
transmitted according to the rules set by other dialing parameters.
Manual Revision: 3.0
BreezeACCESS Version 4.3 Operations and Administration