Alvarion BreezeACCESS II System Manual page 190

2-54
managed by stations whose IP addresses match one of the entries in
the Set Network Management IP Addresses (see next parameter)
that are connected to the unit via the defined port(s). Available
options are:
Disable – No IP address based filtering
Activate Management IP Filter On Ethernet Port – Applicable
only if the Access to Network Management parameter is
configured to either From Ethernet Only or From Both
Ethernet & Wireless Link. The unit can be managed from the
Ethernet port only by stations whose IP addresses match one of
the entries in the Set Network Management IP Addresses list. If
the Access to Network Management parameter is configured
to From Both Ethernet & Wireless Link, than there is no IP
address based filtering on the wireless port.
Activate Management IP Filter On Wlan Port – Applicable only
if the Access to Network Management parameter is configured
to either From Wireless Link Only or From Both Ethernet &
Wireless Link. The unit can be managed from the wireless link
port only by stations whose IP addresses match one of the
entries in the Set Network Management IP Addresses list. If the
Access to Network Management parameter is configured to
From Both Ethernet & Wireless Link, then there is no
IP-address-based filtering on the Ethernet port.
Activate Management IP Filter On Both Ethernet & Wlan
Ports – Applicable with all options of the Access to Network
Management parameter. The unit can be managed from the
port(s) defined by the selected option of the Access to Network
Management parameter only by stations whose IP addresses
match one of the entries in the Set Network Management IP
Addresses list.
NOTE:
In the GU only the Disable and Activate Management IP Filtering on Ethernet
Port options are available.
Set Network Management IP Addresses – Displays the IP
addresses of the stations that can manage the unit (if Network
Management Filtering option was enabled) and allows you to enter
new addresses; up to three IP addresses can be defined.
The default value is 0.0.0.0 for all 3 addresses.
Delete a Network Management IP Address – Deletes one of the 3
IP address entries from the list of Network Management IP
Addresses.
Delete All Network Management IP Addresses – Deletes all entries
from the list of Network Management IP Addresses.
Manual Revision: 3.0
The default selection is Disable.
BreezeACCESS Version 4.3 Operations and Administration