Table of Contents
Advertisement
Chapter 2 - Installation
Figure 2-13 below illustrates the method of installing an Outdoor Unit
on a pole, using the brackets and open-ended screws.
Figure 2-13: Installation Using the Special Brackets
NOTE
Be sure to insert the open-ended screws with the grooves pointing outward, since
these grooves enable you to use a screwdriver to fasten the screws to the unit.
Connecting the Antenna Cable
Connect an RF cable between the antenna and the antenna connector
in the outdoor unit. The antenna connector of the outdoor unit is
located on the top panel.
Connecting the Ground and IF Cables
The ground terminal, which is marked with the symbol and the IF
cable connector (marked IF) are located on the bottom panel of the unit,
as shown in Figure 2-14.
2-14
BreezeACCESS LB System Manual
Advertisement
Table of Contents
Troubleshooting
