Configuring Parameters In Gu-A-Bs Units; Introduction - Alvarion BreezeACCESS II System Manual

1-6
Table 1-3: Subscriber and Access Units Basic Parameters
Parameter
Receive Attenuation Control
(IF-based SU)
Scanning Mode (SU)
ESSID
Operator ESSID Option (AU)
Operator ESSID (AU)
Best AU Support (SU)
Preferred AU MAC Address
(SU)
VLAN Link Type
VLAN ID – Management
Authentication Algorithm
Default Key ID (SU)
WEP Key 1-4
: Subscriber and Access Units Basic Parameters: Once the basic
parameters are configured, the unit must be reset in order to activate
the new configuration.
Configuring Parameters in
GU-A-BS Units

Introduction

This section describes all the parameters that are necessary for the
initial installation and operation of GU-A-BS units. Once the unit is
properly installed and operational, other parameters can be configured
using the monitor program via Telnet or SNMP management.
NOTE:
The BS-GU does not have an external MON port, and therefore must be configured
using Telnet.
Since all the parameters needed are found in the Advanced
Configuration menu, Administrator level access is required in order to
configure a GU-A-BS unit.
Manual Revision: 3.0
Default Value
0
Active
ESSID1
Enable
ESSID1
Disable
00-00-00-00-00-00 (none)
Hybrid Link
65535
Open System
1
0000000000 (none)
BreezeACCESS Version 4.3 Commissioning
Comment
Applicable only when Best AU
Support is enabled
In the SU, can be changed to
Shared Key only after
configuring the WEP Key and
the applicable Default Key ID.
In the AU at least one WEP key
must be configured.