Alvarion BreezeACCESS II System Manual page 148

2-12
c. The address of the TFTP server and the proper name of the
configuration file must be configured in the DHCP server:
The unit shall initiate a request for a configuration file in the
following cases (provided the DHCP Option is enabled):
a. After power-up reset (HW reset), provided the Auto
Configuration Option is enabled.
b. Upon enabling the Auto Configuration Option.
c. Upon a user initiated request.
NOTE:
If the response messages from the DHCP server after the requests for TFTP Server
Name and Boot File Name do not include these options, or if invalid values have been
received, this DHCP server will not be used for automatic IP parameters assignment.
The Auto Configuration Parameters sub-menu includes the
following options:
Auto Configuration Option – To disable or enable the Auto
Configuration mechanism.
The default is Disable.
Request Auto Configuration – To initiate an Auto
Configuration process.
NOTE:
Upon completion of the Auto Configuration process the unit will reset
automatically.
Show Auto Configuration Parameters – Displays the status of
the Auto Configuration Option and the Auto Configuration
Received Status (Received/Not Received), indicating whether
an Auto Configuration File has been received.
SNMP Read ESSID – This parameter is available only under
Administrator access rights. For security reasons, the values of
some parameters, including ESSID and Run Time ESSID, can be
viewed (get) using SNMP only with the Write Community string, and
are not available with the Read Community string. When this
parameter is enabled, it allows viewing (get) the values of ESSID and
Run Time ESSID with the Read Community string as well.
Manual Revision: 3.0
The Server Address should be specified in the 'sname' field of
the DHCP header. The code for this option is 66, and the
minimum length is 1. It must include a legal IP address, with
a maximum length of 64 characters (maximum length
includes spaces. Extra characters will be ignored).
The Configuration File Name should be specified in the 'file'
field of the DHCP header. The code for this option is 67, and
the minimum length is 1. The maximum length is 128
characters (maximum length includes spaces. Extra
characters will be ignored).
BreezeACCESS Version 4.3 Operations and Administration