Alvarion BreezeACCESS II System Manual page 191

Menus and Parameters
SNMP Traps – This submenu enables configuring SNMP Traps
sending parameters. It includes the following options:
Traps Control - Enables/disables transmission of SNMP traps;
Trap
Send SU Associated AU Trap
Send Disassociated Trap
Send AU Aging Trap
Send AU Wireless Quality Trap
Send SU Associated Trap
Send SU Wireless Quality Trap
Send Parameter Changed Trap
Send GPS Alarm In Trap
Send GPS Alarm Out Trap
Send UTC Status Trap
Send Power Up From Reset Trap
Send Monitor Status Trap
Send Cold \ Warm Start Trap
Send AU Loss Of Sync Trap
Send SNMP Traps – Enables/disables sending of SNMP
traps. Available options are:
Enable Traps Sending - enables sending of SNMP Traps.
The Traps that will be sent can be defined by the Per
Trap Control menu. The addresses to which these traps
will be sent and the SNMP Communities associated with
these Traps are defined by the SNMP Traps IP
Destination and the SNMP Traps Community options.
Disable Traps Sending - no SNMP Traps will be sent by
the unit.
The default selection is Disable Traps Sending.
Per Trap Control - When SNMP Traps Sending is enabled,
this menu allows defining for each individual Trap whether it
will be transmitted or not. The Traps that can be controlled
and the default option for each Trap are detailed in
Table 2-6.
Table 2-6: Per Trap Control
Unit
AU
AU
AU
AU
SU
SU
AU, SU
GU
GU
GU
All
All
All
BS-AU in slave mode
BreezeACCESS Version 4.3 System Manual
Default
Enable Trap Sending
Enable Trap Sending
Enable Trap Sending
Enable Trap Sending
Enable Trap Sending
Enable Trap Sending
Enable Trap Sending
Enable Trap Sending
Enable Trap Sending
Enable Trap Sending
AU, GU: Enable Trap Sending
SU: Disable Trap Sending
Enable Trap Sending
AU, GU: Enable Trap Sending
SU: Disable Trap Sending
Enable Trap Sending
2-55