Basic Configuration Menu - Alvarion BreezeACCESS II System Manual

Menus and Parameters

Basic Configuration Menu

The Basic Configuration menu includes all the parameters that are
necessary for the initial installation and operation of the unit. Once the
unit is properly installed and operational, other parameters can be
configured either locally using the monitor program or remotely using
Telnet, SNMP management or TFTP for loading to the unit a
pre-prepared configuration file.
For more information about the initial configuration of BreezeACCESS
units, see Book 3: Commissioning.
The Basic Configuration menu includes the following submenu
parameters:
IP Parameters
IP Address
Subnet Mask
Default Gateway Address
DHCP Client
Air Interface Parameters
ESSID
Operator ESSID Parameters (AU)
Hopping Sequence
Hopping Set (see page 2-38)
Hopping Sync (AU-BS)
Transmit Antenna (SU-R, SU-I/I-D)
Transmit Power Control (IF-based units)
ATPC Option (IF-based units)
Receive Attenuation Control (IF-based SU)
Power Level (SU-R and SU-I/AU-I only)
Best AU Parameters (SU)
Best AU Support
Preferred AU MAC Address
Maximum Data Rate (SU)
Scanning Mode (SU)
(see page 2-36)
(see page 2-36)
(see page
(see page 2-37)
(see page 2-40)
(see page
(see page
(see page
(see page
(see page
BreezeACCESS Version 4.3 System Manual
2-36)
(see page 2-40)
2-37)
2-39)
(see page 2-50)
(see page
(see page 2-47)
(see page
(see page
2-41)
2-47)
2-52)
2-13
2-44)
2-50)
2-45)