Table of Contents
Advertisement
56
9
Connect the flat, white connector to the back of the included remote battery box. Make sure
the two guides are on the top of the connector when inserting it into the battery box.
10 Attach the remaining connector with the red and black wires to the wire harness where the
battery box was disconnected from in step 4.
11 On the back side of the panel you removed there be a bracket with two wing nuts. Remove
the wing nuts and set aside for reinstallation.
12 Align the two holes on the bottom of the receiver assembly with the studs and secure the
assembly to the bracket using the two wing nuts removed in the previous step.
© Travis Industries
Installation
(for qualified installers only)
Make sure the guides
are facing upward
11/9/20 - 1478
PB 72 GSB2/GSR2 Aust.
Advertisement
Table of Contents
