Table of Contents
Advertisement
52
7. Install the LP pilot orifice following the instructions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace
the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
a
© Travis Industries
Installation
(for qualified installers only)
Natural Gas Orifice = .018N
LP (Propane) Orifce = .014LP
7/16" Wrench
.018N
.014LP
11/9/20 - 1478
b
PB 72 GSB2/GSR2 Aust.
Advertisement
Table of Contents
