Table of Contents
Advertisement
48
3
Spread an even layer of crushed glass over the media tray and burner. The glass must be only 1
layer thick on the burner but can be 2 layers thick on the media tray. Make sure no glass is in the
pilot area indicated in the picture below.
4
Make sure the rear and end air channels are free of crushed glass. Use a screwdriver to clear this area.
Make sure the glass is only 1 layer deep on the burner.
5
Remove the pilot shield to uncover the pilot once you are finished placing the glass.
© Travis Industries
Installation
(for qualified installers only)
No glass in
this area
One layer thick
11/9/20 - 1478
2 layers thick
PB 72 GSB2/GSR2 Aust.
Advertisement
Table of Contents
