Lopi Pro Builder 72 Linear GSB2 Installation Manual page 44

44
2. Remove the glass frame following the directions below.
Open the latches holding the glass frame in place (start with
a
the bottom) - follow the directions shown to the right.
Lift the glass frame up and
b
pull it forward to remove.
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions to the right in reverse).
c) Lift the glass frame slightly and attach the lower latches.
NOTE: Make sure the glass frame is all the way in place - it should
be parallel with the front of the fireplace when installed.
NOTE: Make sure the glass frame is all the way in place – It should be parallel with the front of the
fireplace when installed.
© Travis Industries
Installation
(for qualified installers only)
NOTE:
You may need to lift
the glass frame
while re-attaching.
Replacement Glass Frame Part #
72 ProBuilder
Pliers may be used
Latch
Catch
(on glass frame)
250-04654
11/9/20 - 1478
Top of
Firebox
Glass
PB 72 GSB2/GSR2 Aust.