Table of Contents
Advertisement
During an initialize, the Web browser is unable to communicate with
the stack. After the initialize, communication is restored. The
initialize process takes about 10 seconds.
Reset
This page is used to reset the stack. Resetting the stack simulates
powering on and powering off the stack. You may want to do this if
you want to reset the stack's statistics counters.
CAUTION: Performing a reset may cause some of the data being
transmitted over the network to be lost.
During a reset, the Web browser is unable to communicate with the
stack. After the reset, communication is restored. The reset process
takes about 10 seconds.
Resilient Links
This page shows the resilient links that have been set up for the
stack, as shown in
Only media that generates a link pulse (for example twisted pair and
fiber optic) can be part of a resilient link. This means that you can use
the TP ports on the front of the Dual Speed Hub 500 and the
transceiver module ports on the rear (if fitted with modules that have
the required media).
Figure 20 Resilient Links Page
Figure
20.
Configuration Pages
95
Advertisement
Table of Contents
