Using The Reset To Default Icon; Resetting By Using The Configuration Button - 3Com WL-311 User Manual

Using the Reset to Default Icon

To reset the wireless bridge unit configuration settings to their factory default values,
follow these steps:
1 From the Wireless Bridge Configuration screen (see "Selecting a Bridge to Configure"
on page 15), select the Tools tab.
2 Double-click the Reset To Default icon.
The Reset To Default screen appears, asking you to verify that you want to restart the
bridge unit.
3 Click Yes to restart the unit.

Resetting by Using the Configuration Button

You can also reset the 3Com Wireless Building-to-Building Bridge to factory default
settings without using the Bridge Manager:
1 Disconnect power to the bridge.
2 Insert one end of an extended paper clip into the small hole labeled Config. (located
near the serial port on the bridge back panel) to press the configuration button.
3 While keeping the configuration button pressed, reconnect power to the bridge.
Press the configuration button for at least five seconds after power is applied. The
bridge will be reset to factory defaults once the lights start to blink.
Resetting the Unit to Factory Defaults
29