Enabling And Disabling Remote Access To The Stack; Enabling And Disabling Rmon Filter Capture - 3Com 3C16685 User Manual

To initialize the stack:
1 At the top-level menu, enter:
system initialize
2 The command line interface asks you to confirm the initialize. Enter y
if you wish to proceed, or n if you want to stop the initialize.
During an initialize, you are unable to communicate with the stack.
After the initialize, press Return twice to restore communication
(if required). The initialize process takes about 10 seconds.

Enabling and Disabling Remote Access to the Stack

As a security measure, you can enable or disable remote access to
the management software of the stack:
When remote access is enabled, users can access the
management software using all management methods.
When remote access is disabled, users cannot access the
management software over the network. This includes remote
access using:
To configure remote access:
1 At the top-level menu, enter:
system remoteAccess
2 Enable or disable remote access as required.

Enabling and Disabling RMON Filter Capture

You can enable or disable RMON Filter capture. By default this is
enabled. You may wish to disable this if you have no requirement to
perform RMON packet monitoring and wish to increase the security
of your network.
RMON Filter capture is enabled and disabled on a per unit basis.
If you want to change Filter capture for the whole stack, you must
perform the command for each unit (accessing each unit in turn).
The command line interface (over Telnet)
The web interface
An SNMP network management application
An RMON management application
Commands 67